Biosensors based on nano-scale electronic devices have the potential to achieve exquisite
sensitivity for the direct detection of biomolecular interactions. Silicon nanowire field effect
transistors (Si NW FET) are the most promising candidates for these purposes because of their
biocompatibility, very high surface-to-volume ratio, fast response, and good reliability of the
signal. In the last decade, several promising results based on Si NW sensors, which were either
fabricated by “top-down” or “bottom-up” approaches, have been reported.
However, a fundamental understanding of the principle determining the signal-to-noise ratio
(SNR) of the Si NW FET biosensors is still not well understood.
The aim of this PhD thesis was to fabricate Si NW FETs with optimized techniques based on
the “top-down” approach and to study the electrical transport characteristics of Si NW FETs
with different channel dimensions in order to disclose the intrinsic low frequency noise
properties and hence give the inspiration for biosensor fabrication and application.
Nanoimprint lithography (NIL) and wet anisotropic etching were employed in the fabrication
of our devices. In order to increase the size resolution, reproducibility and stable electrical
operation properties, KOH chemical etching was used to fabricate imprint mold.
Four kinds of Si NW FETs were fabricated using the optimized CMOS compatible technologies
in the cleanroom of the Helmholtz Nanoelectronic Facility (HNF), Forschungszentrum Juelich,
Germany.
The electrical transport properties of Si NW FETs were characterized by both current-voltage
characteristics and low frequency noise measurements using different configurations,
including back gate control (VBG) and front gate control (VFG) in ambient conditions and in
liquid environments, respectively. It was demonstrated that the magnitude of the flicker noise
depends on the channel dimensions and that the signal to noise ratio increases with the
shrinking of the channel dimensions. Furthermore, random telegraph signals (RTSs) were
registered in devices with short channels and Coulomb Blockade energy was evaluated from
the real time and low frequency noise measurements at different temperatures in a back gate
configuration. RTS noise was also found in the front gate configuration at different pH values
and different gate voltages. It was demonstrated that the capture time constant of the RTS
can be used as a sensor analysis with a higher sensitivity of signal detection in sensor
applications than conventional drain current measurements and the sensitivity can be further
improved by a special design of the structures.
Jing Li