Increasing the delivery pressure of high-pressure gasoline pumps for direct injection engines by the use of ceramic components
Buch in deiner Nähe kaufen
Beschreibung
The fuel consumption of modern combustion engines can be significantly reduced through the use of gasoline direct injection (GDI). As the time for mixture preparation in GDI engines is very short, the fuel has to be injected at high pressure into the combustion chamber. Modern injection systems provide an injection pressure of up to 20 MPa, whereas investigations performed at the Karlsruhe Institute of Technology have shown strong potential for reduced pollutant emissions by increasing the pressure to 80 MPa. However, the low lubricity of gasoline causes sever friction and wear in the high-pressure pump at fuel pressures above 20 MPa. The use of ceramic components in the sliding systems should help to overcome this limitation. A 3-piston radial pump based on ceramic sliding systems that delivers fuel at up to 80 MPa has been designed at Karlsruhe Institute of Technology. The prototype is based on the knowledge accumulated during former investigations performed on a single-piston pump. It is fitted with pressure and temperature sensors in each cylinder and a torque sensor on the driveshaft in order to measure its efficiency with various material combinations in its sliding systems. The results show that the use of ceramic material such as silicon carbide or sialon enable operation at injection pressures of up to 80 MPa with very good mechanical efficiency and low wear.
Autor*in
Christophe Pfister
Themen in »Increasing the delivery pressure of high-pressure gasoline pumps for direct injection engines by the use of ceramic components«
Benzin Direkteinspritzung Hochdruckpumpe Gleitsysteme Keramik Tribologie